MR33 Junsi iCharger 3D Stand Yokomo BD12 Step2: Install and tighten the

Step2: Install and tighten the nut (ST134) on ST121 via 7 mm wrench

Changing roll centres on your Awesomatix has never been easier

The short chassis reduces scrubbing

Tyre preparation

Apply 1up Gold to the inner channel of the Hardened Steel Diff Lockout as shown

MR33 Junsi iCharger 3D Stand Yokomo BD12 Step2: Install and tighten theWith this 3D printed MR33 Junsi charger holder (made by Boom RC) you can finally create order and space on your screwdriver table. The holder is made of high quality, 3D printed parts and can be mounted on almost any common power supply. Simply stick the holder onto your power supply in the desired position using the double sided adhesive tape done! Your Junsi charger will find a good position on the holder, and you can also read the display even more